– see the
Germination by Nature® page
1.
When watering your
seeds after planting, each 7 days use a mixture of 1/4 ounce of
Root by Nature® to one gallon of
water (10 ml to 5 Liters). {metric
conversion table}
2.
The Sound by Nature® unit should
be operational for 30 minutes prior to spraying or watering each time
you spray or water with the Plant by Nature® nutrients.
3.
After the tree
seedlings emerge from ground spray them with a mixture of
Foliar by Nature® at the rate of 1/4
ounce per gallon (10 ml to 5 Liters) of water once a week until they
are transplanted into their permanent home.
4. When you
Transplant the seedlings or do any grafting or pruning it is
recommended that you water the roots with a mixture of 1/2 ounce per
gallon of
Transplant by Nature® immediately
after transplanting or grafting.
5. This watering
should be followed up 7 days later with a watering of
Root by Nature® diluted at 1/2 ounce
per gallon (20 ml to 5 Liters) of water
Recently Transplanted and
Adolescent Trees
For rapid accelerated
growth and earlier production, trees should be sprayed during
non-dormancy periods for maximum effect.
Spray as follows: {Spray
instructions}
1.
Spray the
Foliar by Nature® mixture dilution of
1:330 (10 ml nutrient per 4 Liters of water) for twice a month for
the first two months after transplanting and once a month after that.
Spraying a sufficient amount for coverage on both sides of the leave
surface is all that is required. {metric
conversion table}
2. Foliar
by Nature® is ideally suited
to high pressure spraying.
3.
The
Sound by Nature® unit should be on 30
minutes prior to spraying or watering.
4. Water the trees at least once every 7 days with a mixture of 1/4
ounce of
Root by Nature® to one gallon of
water (10 ml to 5 Liters).
Trees in production
Do not knock off the
flowers with the spray.
Spray 1/3 oz. per gallon water
1:330 (10 ml
Foliar by Nature® nutrient per 4
Liters of water) just prior to first major flowering. To achieve
maximum production from tree blossoms, spray
Bloom by Nature
® either three days
before or after using
Foliar by Nature® nutrient. If the
tree blooms in more than one cycle, repeat for each cycle.
First Spray: Pre Bloom
Second Spray: Petal tight (tight cluster)
Third Spray: Full Bloom
Fourth Spray: Two or Three weeks past abortion stage.
Fifth Spray: Six weeks later. Continue to spray at least once each 6
weeks until the fruit has reached full growth.
For maximum production we recommend that you water the trees weekly
with a mixture of 1/4 ounce of
Root by Nature ® to one gallon of
water (10 ml to 5 Liters).
For Cocoa Trees
1. Spray 1/3 oz. per gallon
water 1:330 (10 ml
Foliar by Nature® nutrient per 4
Liters of water) just prior to first major flowering. To achieve
maximum production from tree blossoms, spray
Bloom by Nature ® either three days
before or after using
Foliar by Nature® nutrient.
2. Then at full bouquet (full flowering).
3. Additional spray one month after full flowering.
4. And again one month later. (two months after full flowering).
5. Spray just prior to second major flowering and at second full major
flowering.
6. Spray one month after second flowering.
7. Additional sprays can be applied at one month intervals if desired.
For maximum production we recommend that you water the trees weekly
with a mixture of 1/4 ounce of
Root by Nature® to one gallon of
water (10 ml to 5 Liters). Each tree should receive at least one
gallon of the dilute nutrient.
For Palm oil trees
Spray 1/3 oz. per gallon water 1:330 (10 ml Plant by Nature®
nutrient per 4 Liters of water) once each 30 days.
For maximum production
we recommend that you water the trees each 14 days with a mixture of
1/4 ounce of
Root by Nature ® to one gallon of
water (10 ml to 5 Liters).
Plant by Nature is Organic Gardening Nature's Way.
